Aladdin-light-lift ALL1000-CM(Two Circuit Fixtures Only) Manuale Utente

ALL1000-3300W INSTALLATION INSTRUCTIONSAladdin Light Lift, Inc. (256) 429-970061 Shields Road (877) 287-4601Huntsville, AL 35811 www

STEP 23Adjust screw collar rings so top of canopy is just below edge of bottom contact plate. Canopy should be at least 1 ¾” deep. See Diagram I.Neve

STEP 27Tighten xture coupler set screws using supplied 3/32” Allen wrench. Fixture coupler set screws have thread lock already applied at factory. S

ALL1000 TROUBLESHOOTING GUIDETECH SUPPORT: (877) 287-4601 Monday through Friday 8:00am to 4:00pm CSTI. Troubleshooting and installation must be perfo

ALL1000 TROUBLESHOOTING GUIDE cont. 1. Conrm ALL1000 is at the CEILING POSITION. If not, use the controller to operate the ALL1000 to the CEILING P

Read the following guidelines prior to installing the ALL1000:I. e ALL1000 must be installed by a licensed, bonded and insured electrician. II. e A

STEP 1Determine where ALL1000 will mount on ceiling joists. ALL1000 must be installed level, in an accessible location directly above chandelier.Neve

STEP 5Attach the 1/2” conduit connector on ceiling box to bottom of conduit assembly. Once completely inserted, tighten set screw on conduit connecto

STEP 7Position ALL1000 where ceiling box will be centered in ceiling hole. Weight and bottom contact plate assembly should hang down through ceiling

STEP 9Shim and adjust ALL1000 so that winch cable hangs plumb through center of hole in top contact plate on ceiling box. See Diagram E. Look up at

STEP 11Turn o supply power before wiring ALL1000. Turn o motor switch in square box. Wire motor switch with 110V wiring. e 110V motor feed must b

STEP 13Remove dust cover and remove paper tape from winch drum while keeping tension on winch cable.Never operate the ALL1000 without tension on the c

STEP 20Fully thread screw collar loop or threaded stem that was supplied with chandelier to 3/8 IPS xture coupler. If chandelier was supplied with a